BEP 3.0 for Acewell instruments

For all BMW K75, K100, K1 and K1100 customers who are looking for a plug and play solution!

If you order the BEP 3.0 in combination with one of our instruments, we will pre-install your BEP 3.0 here in-house! When placing your order, please indicate under "Comments" whether your vehicle has a fuel gauge or just a reserve gauge! Please also indicate whether your vehicle is equipped with ABS! Not all of our instruments are equipped with an ABS indicator, please note the corresponding indicator lights. You may need a separate red LED. If you have any questions, please contact us or leave us a message.

The BEP 3.0 can be connected to all K75, K100, K1 and K1100. It doesn't matter which tank sensor, whether LT, RT or RS, whether with or without ABS. In any case, all displays are correctly evaluated. All you have to do is select an instrument of your choice and we will configure the connection and connect your instrument to the BEP 3.0 with our plugs so that you can really enjoy a plug and play solution. All you have to do is install the instrument on your vehicle.

You can find a lot more information in the pdf-documents, which we have made available for you to download at the bottom of this page!

You do not need our inverter ACE-IVR03 in combination with the BEP 3.0! Important! You will face these problems without the BEP 3.0:

- The battery is no longer charged - The start button no longer works (only with the clutch pulled) - The signal for the idle indicator cannot be tapped from the wiring harness - The speed signal from the final drive cannot be used - The speed "jitters" because it is not suppressed and digitized - The reserve signal at 4L cannot be used - The automatic indicator reset is not working

The solution:

The BEP 3.0 therefore fulfils all essential functions such as closing the LIMA/battery charging circuit, resetting the indicators or a functioning start button. Simply plug it in and drive off. You don't need to use a soldering iron or cut any cables on the wiring harness to make the conversion. The entire electronics fit into a small 10.3cm x 6.2cm x 2.7cm plastic housing and weigh just 80 grams. It can therefore definitely be described as compact and lightweight.

Attention: the BEP 3.0 is not waterproof! Please install under the tank, protected from the weather. Dimensions: length x width x height = 102 mm x 61 mm x 25 mm

Scope of delivery : 1 x BEP 3.0

1 x instruction manual

without counter connector set (photo 3, if you do not order the instrument)

Please also note that only connection cables up to 0.75mm² are suitable for the BEP 3.0.

A notice:
We, ACEWELL - Technologies, are a cooperation partner of Maru Labs, which produces the BEP 3.0 in Switzerland. http://maru-labs.com/